StarTech.com usb dual vga cat5 kvm console extender - 650ft/200m Manual Do Utilizador

Instruction Manual

7

Video Compensation allows the user to adjust the equalization from the Remote Unit 

console to optimize video performance based on the length of cable being used, as 

well as other factors that may affect the display, with adjustments available for Equalizer 

(Sharpness), Gain (Brightness) and Skew (RGB). To compensate the varying lengths of 

CAT 5 / CAT 5e / CAT 6 cable, there 16 levels on coarse tune and up to 128/256 scales on 

fine tune are available for adjustment on the equalizer and gain. There are also 8 levels 

on coarse tune and 16/32 scales on fine tune are available for skew adjustment on Red, 

Green and Blue. Please refer to the section below titled Hotkey Commands for Remote 

Unit for details on how to apply video compensation settings.

Note:
1.  The video adjustment is available on the Remote Unit ONLY.
2.  The video adjustment is applicable only if the CATx cable is connected and the 

Remote Unit is in control

3.  The idle time-out of Video Adjustment is 30 seconds. That is, it will automatically 

escape from video adjustment status if no activity is detected by the keyboard 

within 30 seconds. 

You can activate video adjustment on the Remote Unit either through hotkeys or push-

button. The Unit is capable of hotkey control whether the Mask Hotkey is OFF or ON. 

When the Video Adjustment mode is activated, the Numeric Lock and Scroll Lock LED 

on the keyboard connected to the Remote Unit will flash respectively. Then, you can 

perform the video adjustment by hotkey commands as the table shown below. 
To exit the video adjustment status, three approaches are available:
1.  No activity is detected by the keyboard for 30 seconds.

2.  Push the Esc key once on the keyboard attached to the Remote Unit

3.  Push the push-button on the top panel of the Remote Unit once

Before Video Compensation

After Video Compensation