Crestron electronic CPC-2000A Manual Do Utilizador

Crestron CPC-2000A 

Touchpanel with Dual Joysticks

touchpanel on the network forces the same page change to all enabled touchpanels. 
Panel tracking is disabled when the PANEL TRACKING button is deselected. 
When disabled a given touchpanel does not respond to page changes made to other 
touchpanels on the network. Panel tracking is factory set with the PANEL 
TRACKING button deselected.  

The touchpanel communicates with a control system to activate other controls or to 
display feedback from components within the system. The communication interface 
must be correctly specified or communication does not occur. To set communication 
parameters select the INTERFACE button located centrally in the top row of the 
Setup Menu and display the Interface Menu, shown to the left of this paragraph.  

The Cresnet network identity number (NET ID) is displayed in the top left corner of 
the Interface Menu. NET ID is the two-digit hexadecimal number represented by ## 
in the figure for illustrative purposes. The hexadecimal number can range from 03 to 
FE and must correspond to the NET ID set in the SIMPL Windows program. 
Matching NET IDs between touchpanel and the program is required if data is to be 
successfully transferred or new touchpanel screens are to be loaded. NET ID is 
factory set to 03.  

Two side-by-side buttons adjacent to the hexadecimal display, < CRESNET ID and 
CRESNET ID >, decrease and increase the NET ID by one, respectively. 

The touchpanel usually communicates with a control system. Occasionally the 
touchpanel can be used in local demo mode where it merely displays various menus, 
but does not communicate with the control system. In local mode, the directory 
buttons change pages, but buttons requiring feedback do not work. Two centrally 
located buttons on the Interface Menu, CRESNET II and LOCAL, determine 
communication mode. Select LOCAL to set the touchpanel into demo mode and 
CRESNET II for normal control system communication mode. Text within the 
selected button changes color from black to red. Communication mode is factory set 
to CRESNET II.  

Two side-by-side buttons, RS-232 ON and RS-232 OFF, are centrally located on 
the Interface Menu. Text within the selected button changes color from black to red. 
Since there is no RS-232 port on the unit, verify that the RS-232 OFF button is 
selected. Furthermore, there is no need to use the RS232 SETTINGS button on the 
Interface Menu.  

The SOUND button, located at the top right corner of the Setup Menu, is used to 
display the Sound Menu, shown to the left of this paragraph. Use this screen to 
activate audible key clicks. This feature is a useful feedback tool. Confirmation of a 
button press on a touchpanel is acknowledged by an audible click assuming this 
feature is enabled. To enable this feature, verify that the KEYCLICK ON button is 
active (red). An active KEYCLICK OFF button disables the feature. Volume of the 
audible click is controlled with the VOLUME UP and VOLUME DOWN buttons. 
The unit is factory set with the sound on.  

Select the RETURN button, located at the lower right corner of the Setup Menu, 
after setup parameters have been set.  

•  9