Electrolux OHV Manual Do Utilizador

46

47

NOTE: Before re-assembling, clean impeller 
shaft where the auger pulley will be installed 
using emery cloth, and lubricate shaft end with 
anti-seize.

NOTE: The Scraper Bar is reversible.  Inspect 
Scraper Bar on snowthrower before ordering a 
replacement.

Replace worn or damaged parts. Replace gas-
ket.  Use 750369 grease.  Torque self-tapping 
screw to 15 Ft.Lbs. max.

3)  With auger housing sitting on its back insert 

gearbox / auger / impeller  as an assembly 
into place.

2)  Check the end of the auger flight.  Stamped 

into the metal is an “L” on the left side or “R” 
on the right as well as the auger width.

4)  Reinstall screws to side of housing to 

secure the auger bearings.

5)  Turn Auger assembly over, put antiseize 

compound on impeller shaft before installing 
pulley.   Torque at 15-20 Ft.Lbs.

6)  Reinstall belt and reattach auger assembly 

to powerhead. (Section 7.61 or 7.31).

1)  Tip snowthrower so that Auger is down and 

handles are up.

2)  Remove the nuts and carriage bolts holding 

the scraper  to the housing.

3)  The scraper bar is reversible and can be 

turned over and reinstalled once before 
replacement is required.

4)  Reuse carriage bolts and nuts to install 

scraper bar. 

1)  Place auger bearings at ends of  auger 

with center notch in bearing toward housing 
ends.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com