Cosmorex SE Manual Do Proprietário

•In the event the flash unit does not fire

when you press the Shutter Release Button
(2), check to see that the flash cord is
securely plugged into Flash Cord Outlet (7)
, and that On/Off switch of flash unit is
in "ON" position. Finally, make certain the
Selector Dial (6) is at "X" position.

D

o not press down on Shutter Release Button (

2) unless actually taking a flash picture.
Pressing this button down fully will fire the
flash whether or not the Film Transport Lever (
1) has been wound. Should this happen,
however, no loss of film will occur.

 A

lways remember to set Shutter Speed Dial (5)

to 1/30th second, and Flash Synch Selector Dial
(6) to 'X' position for electronic flash
photography. At other speeds or settings, the
flash will not synchronize fully with the shutter.

In general, flashcubes and bulbs are more costly
than electronic flash, and less convenient to use
as the bulbs must be replaced after each picture
(with flashbulbs) or each four pictures (with
flashcubes). Should you wish to use these light
sources, however, follow Steps 1-5 above, with
this exception:

or flashcubes or flashbulbs, move the Flash

Synch Selector Dial (6) to "M" position. This
adjusts the timing mechanism of your camera to
insure that the shutter opens when the flash of
the bulb is at its' brightest. Leave the Shutter
Speed Dial at 1/30th second for all flash
pictures.

 D

etermining exposure with flashcubes or bulbs is

done the same way as with manual (non-
automatic) electronic flash units, as described ab
ove.

This manual created and owned by www.
butkus.org/chinon, it should not be found
elsewhere.