Anetsberger Brothers MG Manual Do Utilizador

12

(Continued)

Grill plate is not hot
enough.

1. Check that thermostat control

setting is at desired setting.

2. Check gas supply pressure with all

other equipment operating. (6”
WC for natural gas and 11” WC
for propane, minimum).

3. Check for fans or excessive air

flow over grill surface.

4. Check for dirty/sooty pilot burner.

5. Observe if grill plate temperature

is acceptable.

1.  Yes – Proceed to test #2.
     No – Increase setting.  Skip to
     test #5.

2.  Above – Proceed to test #3.
     Below – Increase gas supply
     pressure.  Skip to test #5.

3.  Yes – Block or turn off air supply.
      Skip to test #5.
      No –P proceed to test #4.

4.  Yes – Clean pilot burner.
     Proceed to test #5.
     No – proceed to test #5.

5.  Yes – Okay.
      No – Replace thermostat.

Black soot accumu-
lation on burners on
under side of grill
plate.

1. Check if pressure regulator is

installed in supply line.

2. Adjust pressure regulator setting by

turning the adjusting slot counter-
clockwise (under the slotted cap).

1.  Yes – Proceed to test #2
     No – Install regulator supplied
     with  unit.  Proceed to test #2.

5.  Check gas supply pressure with all
      other equipment operating. (6”
    WC for natural gas and 11” WC
     for propane, minimum).

6.  Observe if main burners are firing.

5.  Increase if needed, proceed to
     test #6.

6.  Yes - Okay.
     No - Replace thermostat.

(Continued)
Grill plate is cold
(Burners not
firing).