American International Electric SEG-1 Manual Do Utilizador
3.5 Connecting the SEG-1 to a prox.pad plus (RS-485)
Two different methods can be used to connect P5 Connector of the prox.pad plus to the SEG-1:
1. Connect to the RS485 modular jack (front of SEG-1)
2. Connect to the RS485 terminals (rear of SEG-1)
2. Connect to the RS485 terminals (rear of SEG-1)
NOTE: If connection to SEG-1 is NOT located at the prox.pad plus then the connection must be made via
stranded/shielded cable.
stranded/shielded cable.
3.5.1 SEG-1 to prox.pad plus Connection Method 1
The diagram below illustrates the method to connect the prox.pad plus to the RS485 port of the SEG-1 via its RS485 modular jack on
the front of the unit.
the front of the unit.
3.5.2 SEG-1 to prox.pad plus Connection Method 2
The diagram below illustrates the method to connect the prox.pad plus to the RS485 port of the SEG-1 via the TS1 terminal block at
the rear of the unit.
the rear of the unit.
NOTE: The use of stranded/shielded cable in the diagram shows the connection to the SEG-1 across a distance.
Page 8 of 34 Document Number: 6066005, Rev 3.2