Allworx 9212 Manual Do Utilizador

Phone Guide – 9212

7.7 Check the Network Settings

Warning: Do not make any changes to your network settings unless instructed by your System

Administrator.

1. Select

the

CONFIG soft key.

2. Scroll down and highlight Network Settings.

3. Press

the

Select button

a. DHCP – Allows the phone to extract its configuration from the server.

i. Enabled

(Default)

ii. Disabled

b. VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.

i. Enabled

ii. Hub Debug Mode

iii. Disabled

(Default)

c. Remote Plug ‘n’ Play – Key used to set up a remote phone. See the System Administrator.

d. Edit Time Server IP – Option to change the Time Server the phone is logged into.

e. Edit Boot Server IP – The WAN IP address the server is using for the setup of a remote phone.

f. Edit Phone IP – Option will appear if DHCP is disabled. Allows the manual entry of the phone’s

IP.

g. Edit Netmask IP – Option will appear if DHCP is disabled. Allows the manual entry of the

Netmask IP.

h. Edit Gateway IP – Option will appear if DHCP is disabled. Allows the manual entry of the

Gateway IP.

i. Phone VLAN Settings – Option will appear if VLAN is enabled.

i. Enter VLAN ID – 2 (Default)

ii. Enter VLAN Priority – 7 (Default)

j. PC VLAN Settings – Option will appear if VLAN is enabled.

i. Enter VLAN ID – 1 (Default)

ii. Enter VLAN Priority – 0 (Default)

4. Select

the

EXIT soft key.

5. Select

the

YES soft key to save any changes OR select NO to cancel changes made.

7.8 Current Status / Info

1. Select

the

CONFIG soft key.

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

Revised: May 28, 2008

Page 22