BMW 2008 X3 3.0si Manual Do Proprietário

Página de 140
 117
First-aid kit*
Some of the articles in the first-aid kit may be 
used within a limited time only. Check the expi-
ration dates of the contents regularly and 
replace the contents in a timely fashion as 
needed.
The first-aid kit is located under the front pas-
senger's seat.
To open: pull the handle and fold the cover 
downward.
To close: fold the cover up.
Jump starting
When your battery is discharged, you can use 
two jumper cables to start the engine of your 
BMW with power from the battery in another 
vehicle. You can also use the same method to 
help start another vehicle. Use only jumper 
cables with fully-insulated clamp handles.
To avoid the risk of potentially fatal injury, 
always avoid all contact with electrical 
components while the engine is running. Care-
fully comply with the following instructions to 
avoid personal injury and/or damage to one or 
both vehicles.
<
Preparing
1.
Check whether the battery of the other 
vehicle has a voltage of 12 Volts and 
approximately the same capacitance in Ah. 
This information can be found on the bat-
tery.
2.
Switch off the engine of the vehicle provid-
ing assistance.
3.
Switch off any electrical systems and com-
ponents in both vehicles.
Ensure that there is no contact between 
the bodywork on the two vehicles; other-
wise, there is a danger of short circuits.
<
Connecting jumper cables
Connect the jumper cables in the correct 
order; failure to do so could generate 
sparks and cause injury.
<
In your BMW, the so-called jump starting termi-
nal in the engine compartment functions as the 
positive battery terminal, also refer to engine 
compartment overview on page
. Th
symbol + is embossed on the cover.
1.
Open the cover of the BMW jump starting 
terminal, refer to arrow
1.
2.
Connect one terminal clamp of the posi-
tive/+ jumper cable to the positive terminal 
of the battery or to a jump starting terminal 
of the vehicle providing starting assistance.
3.
Connect the second terminal clamp of the 
positive/+ jumper cable to the positive ter-
minal of the battery or to a jump starting ter-
minal of the vehicle to be started.
4.
Connect one terminal clamp of the nega-
tive/– jumper cable to the negative terminal 
of the battery or to an engine or body 
ground of the vehicle providing assistance.
Your BMW has a special nut that serves as 
the body ground or negative terminal, refer 
to arrow
2.
5.
Connect the second terminal clamp of the 
negative/– jumper cable to the negative ter-
minal of the battery or to the engine or body 
ground of the vehicle to be started.
Online Edition for Part no. 01 41 0 014 250 - © 08/07 BMW AG