BMW 2006 525xi Sedan Manual Do Proprietário

Página de 259
 213
2.
Remove and replace the bulb.
Parking and roadside parking lamps
Bulb 5 watts, W 5 W
One bulb each is located above the low beams 
and high beams.
1.
Turn the cover cap for low beams or high 
beams to the left and remove.
2.
Pull out the bulb holder.
3.
Remove and replace the bulb.
Xenon lamps*
The service life of these bulbs is very long and 
the probability of a failure is very low, provided 
that they are not switched on and off an unusual 
number of times. If one of these bulbs should 
nevertheless fail, it is possible to continue driv-
ing with great caution using the fog lamps, pro-
vided traffic laws in your area do not prohibit 
this.
Have work on the Xenon lighting system 
performed only by your BMW center or a 
workshop that works according to BMW repair 
procedures with correspondingly trained per-
sonnel. Due to the high voltage present in the 
system, there is a danger of fatal injuries when 
work is carried out improperly.
<
Parking and roadside parking lamps
In the event of a malfunction, please go to your 
BMW center or a workshop that works accord-
ing to BMW repair procedures with correspond-
ingly trained personnel.
Turn signals, front
Bulb 21 watts, PY 21 W
1.
Turn the bulb holder to the left and remove.
2.
Apply gentle pressure to the bulb while 
turning it to the left for removal and replace-
ment.
Side-mounted turn signals
Bulb 5 watts, W 5 W
1.
Press back against the front edge of the 
light with the tip of your finger, then pivot it 
out.
2.
Turn the bulb holder to the left and remove.
3.
Remove the bulb for replacement.
Side marker lamps, front and rear
To replace, please go to your BMW center or a 
workshop that works according to BMW repair 
procedures with correspondingly trained per-
sonnel.
Tail lamps
Sedan
>
Turn signals: bulb 21 watts, PY 21 W
>
Backup lamps: bulb 16 watts, W 16 W
Online Edition for Part No. 01 41 0 012 211 - © 02/06 BMW AG