BENDIX S-1580 Manual Do Utilizador

1

The vehicle must be parked on level ground.  Switch off the 

ignition and disconnect the battery.
Read and understand this document before beginning work.  

See the General Safety Guidelines on Page 2.  Familiarize 

yourself with the kit contents; kits may feature speakers OR 

vibrating seat motors.
Inspect the windshield area where the camera will be 

mounted for damage/cracks to be sure there will be a clear 

view.
In some cases, it may be necessary to consult the vehicle's 

electrical schematic diagram(s) to plan access to the power 

supply and the turn-signal wiring.

3¼ inch hole saw; wire strippers; wire crimpers; small 

"torpedo"-style level; test light or multimeter; and wire-pulling 

aids.  Depending on the installation, see a list of optional 

tools on the final page.

Plan the entire installation before beginning work.  Some 

key points to bear in mind when planning the installation are:
•  Camera and processor placement  - note that the length 

of the camera cord is approximately 22 in. (550 mm) 

long.

•  Wiring harness routing.
•  Access to the turn-signal wiring.
•  Dash switch location and wiring.
•  Speaker (or seat motor) locations and wiring.
Where you are installing Autovue

®

 LDW system on multiple 

vehicles, standardize the best installation for the model; this 

will assist when troubleshooting.

IMPORTANT:  Before mounting the camera, verify that the 

vehicle is level.
1.  Clean and inspect the inside of the windshield where the 

windshield bracket will be mounted.  Use a denatured 

alcohol-based (or similar) cleaner.  Cracks/distortion/

damage that would interfere with the camera operation 

are not acceptable.  Clean and dry the windshield; the 

presence of grease or dirt will affect the adhesive used 

to hold the camera bracket in place.

1.  Lane Departure Warning processor .   .   .   .   .   1
2.  Camera with windshield bracket   . . . . . . 1
3.  Two 3½-inch speakers with covers 
 (optional) .   .   .   .   .   .   .   .   .   .   .   .   .   .   .   .   .   .   .   2
4.  Vibrating seat motors (optional) . . . . . . . 2
5.  Enable/Disable switch . . . . . . . . . . . . 1
6.  Driver information sticker (not shown) .   .   .   .   1
7.  Wiring harness
 

(16 wire, color-coded; 20 foot) .   .   .   .   .   .   .   .   1

8. Connectors  . . . . . . . . . . . . . . . . . 14
9.  120 Ohm resistors (not typically needed) . .  2
10.  Other wiring harnesses . . . . . (varies by kit)