Burley PRE-2005 Manual Do Utilizador

3

Burley Walk ‘n Roller Manual; models 2003 and earlier

II. Preparation for Installation

The Walk’n Roller requires the assembly and attachment of 3 components: 
handlebar, parking brake, and stroller wheel. These are covered in sections III, V, and 
VII. Each section has its associated part list so that you may confi rm that you have 
received all the parts needed.  If any parts are missing contact Burley, do not proceed 
with installation.

Tools Required:

7/16 inch wrench 

No. 2 Phillips screwdriver 

Torque wrench   

No. 3 Phillips screwdriver

Extension 

 

Some adhesive tape

7/16 inch socket

Note: The No 2 Phillips screwdriver has a shaft diameter of ¼ inch or less 

and is most useful here for making bolts holes through fabric. The No. 3 

driver has a larger shaft (almost 1/3 inch) and is the better fi t for tightening 

the bolts of this assembly.

The locations of the Walk n’ Roller 
components are seen on the left.   
#1 is the handle assembly, #2 is 
the wheel assembly, and #3 is 
the brake.  

The directions around the trailer 
are in reference to the normal 
direction of motion, front being 
forward.

III. Handlebar Installation

Parts included for the Handlebar Assembly:

(1) Padded handle with safety tether 

(1) Handle Receiver –Right side

(1) Roll Bar plastic replacement hinge 

(1) Handle Receiver – Left side

(1) Roll Bar plastic replacement catch 

(4) ¼” by 1-1/8” Phillips head bolts

(4) ¼” locking nuts 

 

 

(2) ¼ inch standard nuts

(1) ¼ “ jam locking nut (hinge)

 

Note: Standard nuts are larger width, across the hex and do not possess 

a nylon locking ring. The locking nuts have a nylon ring built in. A jam nut 

is thinner, requiring less height on the bolt. In assembly, when replacing 

similar parts, use the new nuts provided.

1

2

3

Left

Right

Front

Back