McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

To view details about this circuit and its provider interfaces, 
double-click on the circuit connection in the network diagram.

Once you have completed the above steps for a 2x2 Gigabit 
Ethernet WAN configuration, your network map should look like 
the following example:

19. Repeat steps in the “Adding an IP Circuit” section to create the 

second IP circuit.

20. Continue the configuration process by following the “Creating 

Data Paths for Fibre Channel Switch Interfaces” section.

After configuring the IP circuit, you need to establish a connection 
between the Fibre Channel Switch interfaces by creating a data path. 

The following example illustrates the creation of a data path for a 2x2 
configuration, where each node has a 2-port Fibre Channel Switch 
interface. This example can also be used for creating a data path 
between two 1-port Fibre Channel Switch interfaces. The only 
difference in data path creation for 1-port and 2-port Fibre Channel 
Switch interfaces is in the way UltraNet ConfigManager numbers the 
Fibre Channel Switch interfaces.

For example, if you were creating a data path between two 1-port 
Fibre Channel Switch interfaces and you had a Node10 and Node20, 
the Fibre Channel Switch interface on Node 10 would be numbered 
10-2 and the Fibre Channel Switch interface on Node20 would be 
numbered 20-2. Whereas in the case of a 2x2 configuration with 
2-port Fibre Channel Switch interfaces and the same nodes