McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

Preface

xix

Preface

Appendix B, Installation and Cabling,

provides information

regarding the installation process, including instructions for
connecting the network cables to the UltraNet Edge 3000.

Appendix C, Serial Cables and Adapters,

lists the RS-232 cables,

the DB connectors, and the pinouts for the DB connectors
available through McDATA. It also contains cable and connector
specifications for the Fibre Channel, 10/100 Ethernet, Gigabit
Ethernet, and ATM/POS OC-3 interfaces.

Appendix D, Advanced UCM Configurations,

provides

additional UltraNet ConfigManager (UCM) configuration
options that are beyond the typical Edge network configurations.
The topics covered are; Configuring the Internal McDATA Fibre
Channel Switch Interface, Time Synchronization Protocol,
Transport CRC Checking, E_Port Disk Streaming Settings, and
F_Port Disk Streaming Settings.

Appendix E, Static Routes,

describes how to display, verify, add,

and modify static routes.

Appendix F, Configure SNMP,

provides an overview for

configuring SNMP on the UltraNet Edge 3000.

Appendix G, Resetting the System to Factory Default,

provides

the procedure for resetting the system to the factory settings
using the sysclean command.

Appendix H, Manual Configuration of the Initial IP Settings,

provides the procedures for the initial configuration of the IP
settings if UltraNet ConfigManager is not used.

Appendix I, Using the Set Spantree Portfast Command on Cisco
Routers,

provides information about the spantree portfast

command for Cisco routers.

Appendix J, Configuration Worksheets,

provides worksheets to

aid in network configuration.

NOTE:

The customer is responsible for ensuring conformance with power

and specifications provided in this guide, for ensuring adherence to federal,
state, and local building and electrical codes, for providing and installing
communication cables on other vendors’ equipment, and for providing a
storage area.