McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

This section does not provide a complete listing of the commands 
issuable on the UltraNet Edge 3000, for information on these and 
other commands issuable on the UltraNet Edge 3000 please refer to 
the UltraNet Edge Storage Router Command Reference on the UltraNet 
Edge Storage Router Technical Documentation Library CD. 

For troubleshooting information on FC/SCSI Tape Pipelining, see the 
“Troubleshooting FC/SCSI Tape Pipelining (Device Extension)” 
section in this chapter.

Use the following procedure to display the user interface commands.

1. Telnet into the Ethernet maintenance interface of the UltraNet 

Edge 3000.

2. To display the menu of all the possible commands on the 

UltraNet Edge 3000, type 

 at the main menu prompt.

tm.0x20> help

The list displayed after typing the 

 command will show 

every possible command that can be typed at the main menu 
prompt. Some commands will enter into their own user interface 
with their own submenu of commands. When you enter into 
another user interface, type 

 again to display that user 

interface’s submenu of commands.

The IP user interface is used to display configured IP interfaces. The 
commands in the IP user interface are useful when troubleshooting 
WAN connectivity problems. The IP interface provides information 
regarding the IP addresses in the network and routing information 
within the node. 

For further information on the IP user interface commands, refer to 
the ip commands section in the “Nucleus Commands” chapter of the 
UltraNet Edge Storage Router Command Reference. The following 
sections highlight the commands useful for troubleshooting.

This command displays the current status of all IP defined interfaces 
and any "attached" users. 

This command displays the current status of the routing IP 
forwarding table for the UltraNet Edge 3000 and is useful when 
diagnosing routing problems within the IP network.