McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

 

This command issues an inquiry to all devices listed in the 
UltraNet Edge 3000’s FC/SCSI Tape Pipelining LUN map. The 
output from this command lists which devices the UltraNet 
Edge Storage Router can access.

c. Run the 

command again. 

The information obtained from the inquiry (

) will 

now be included in the UltraNet Edge 3000’s FC/SCSI Tape 
Pipelining LUN map.

5. Are the devices mapped in the correct order in the UltraNet Edge 

3000’s FC/SCSI Tape Pipelining LUN map?

In most cases, the order of the devices does not matter. If you’re 

trying to re-order the devices through a FC-SCSI bridge, see step  in this 
section.

a. Run the 

command to inspect the UltraNet Edge 

3000’s FC/SCSI Tape Pipelining LUN map.

b. If reordering is required, issue the 

command. 

This command removes all dynamically discovered

 

entries 

from the table.

c. Issue the 

command to display the list of 

purged entries.

d. Issue the 

command where x is the entry 

listed in the purged entries table to be placed in the UltraNet 
Edge 3000’s FC/SCSI Tape Pipelining LUN map at LUN 1.

e. After an entry is removed from the purged entries table, issue 

the 

command to display the new purged 

entries table.

f. Continue issuing the 

and 

commands until the LUN map is complete.

g. This LUN map is automatically saved to disk. 

The 

 command only temporarily removes 

entries from the LUN map. These entries may be included 
back in the LUN map after the UltraNet Edge 3000 reboots. To 
permanently remove an entry from the LUN map, issue the