McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

 UltraNet™ Edge Storage Router 3000 User Guide 

Use the following procedure to unpack and inspect your hardware:

1. Cut the tape and open the cardboard covers.

2. Lift the chassis up and out from the cardboard box.

3. Place the unit on a static-free or static-controlled surface.

4. Remove the antistatic wrapping from the UltraNet Edge 3000.

5. Make sure you have all the items listed on the packing list(s). If 

any items are missing or broken, please contact your McDATA 
representative.

The UltraNet Edge 3000 unit can be placed on a table or mounted in 
an equipment rack. Observe all recommended clearances as stated in 
“Clearance Requirements” in Appendix A. 

Place the UltraNet Edge 3000 unit on a level, stable surface. Do not 
place in direct sunlight or near a heat vent.

To install the UltraNet Edge 3000 unit in an equipment rack, use the 
rack mount bracket ears and screws shipped with your UltraNet 
Edge 3000 unit and proceed as follows.

 #2 Phillips screwdriver.

Depending on the rack mount type, it may require two people to 

mount the UltraNet Edge 3000. One to hold the unit in position while the 
other attaches it to the rack mount. 

1. Using a #2 Phillips screwdriver and eight 6-32 1/4” flathead 

undercut Phillips screws (four for each bracket ear), attach the 
two bracket ears to the front corners of the UltraNet Edge 3000 
unit.

— For a flush mount, position the brackets even with the front of 

the UltraNet Edge 3000 unit and attach them using the holes at 
the front of the brackets.