McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

This section provides information about the Gigabit Ethernet (Gig-E) 
interface configuration, cabling and optional transceivers.

Use this section to connect the cabling for the Gig-E interface.

1. Locate the I/O interface configured as Gigabit Ethernet.

2. Locate the cable with the standard LC connector.

3. Align the cable connectors (Receive (Rx) and Transmit (Tx) with 

the Gig-E interface Rx and Tx. Gently insert the connector. 

Use this section to remove the cabling from the Gig-E interface.

1. Grasp the LC connector at the end of the fiber optic cable.

2. Depress the LC connector clip located underneath the connector 

before pulling to remove the cable from the I/O.

The Gig-E connection uses the standard LC connector. Either short 
wave (multi-mode) or long wave (single-mode) transceivers can be 
used with the Gig-E interface card. The specifications are located in 

. Instructions for 

Sb040

Transmit

Receive

Sb128

LC Connector Clip

Fiber Optic
Transceiver

Fiber Optic
Cable