McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Manual Do Utilizador

This chapter contains the procedures for configuring your UltraNet 
Edge 3000 for E_port extension over an Ethernet WAN using 
McDATA’s UltraNet ConfigManager configuration tool. This chapter 
also covers how to configure your UltraNet Edge 3000 for E_port 
Disk Streaming, which uses a subset of our Fibre Channel Device 
Extension technology and allows data to be moved more efficiently 
than our standard E_port solution. The configuration process is the 
same as E_port extension with an additional single attribute in the 
UltraNet ConfigManager application. Prior to configuring the 
UltraNet Edge 3000, you should be familiar with Fibre Channel, 
10/100 Ethernet, and Gigabit networking principles. You will need to 
gather the IP addresses for your UltraNet Edge 3000 to configure an 
Ethernet WAN. See the UltraNet Edge Storage Router Configuration 
IP Address Worksheet in Appendix J.

To configure your UltraNet Edge 3000 for an Ethernet WAN, the 
following eight procedures are necessary. Complete each procedure 
in the order shown below:

1. Gathering the IP Addresses

2. Starting UltraNet ConfigManager

3. Adding Nodes for an Ethernet WAN Configuration

4. Setting the Initial Configuration

5. Setting the License Information