Lucent Technologies Speaker 585-210-940 Manual Do Utilizador
Installing Mirrored Systems
CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Factory installation procedures for disk mirroring
30
Step 4: Check the
disk.type file
disk.type file
2
The
olds
commands, which you will be using to configure the
Solstice
DiskSuite software, obtain information about your disk configuration from
the
the
/olds/disk.type file. If your boot disks are not as specified in the Disks
table in Step 2, check the
disk.type file to verify that it names the proper
boot disks for your system.
The relevant portion of the
disk.type file looks like this:
The
bootdisk1 column designates the first boot disk; the disk2 column
designates the second boot disk in a mirrored configuration. In order for
the
the
olds commands to work, the disks.type file must match your physical
configuration: you must have disks in the locations specified in the file.
Step 5: Set up the
disk subsystem for
Solstice DiskSuite
disk subsystem for
Solstice DiskSuite
2
1. Set the environment to the Korn Shell by entering these commands:
(where
<ctrl-H> indicates you should press and hold the Control key
as you press the H key).
The
stty command sets up your backspace key as an actual
backspace. If you do not enter this command, you will have to use
the Delete key as a backspace.
the Delete key as a backspace.
2. Make sure the CMS CD is loaded in the CD-ROM drive.
3. Copy the
Solstice DiskSuite setup scripts from the CD to the boot
disk by entering the following commands:
4. Alter your path:
#arch
config
bootdsk1
disk2
scsi control
#Enterprise 3000
sun4u
notmirrored
c0t0d0
c0t1d0
dontcare
sun4u
mirrored
c0t0d0
c0t1d0
controllers=0
# stty
erase
<Ctrl-H>
# ksh
-o
vi
# mkdir
/olds
# cp
/cdrom/cdrom0/cms/reloc/rdonly/olds_install/*
/olds
# cd
/olds
# chmod +x /olds/olds
# export
PATH=$PATH:/usr/opt/SUNWmd/sbin:/olds
#