Lightwave Communications USB-Wizard Manual Do Utilizador

CASCADING

The

USB Wizard can be cascaded as shown in Fig. 6 below.

USB Wizard switches are being cascaded, configure

the dip-switches accordingly (see Tables 1 and 2 on page 8).

Configuration

All units are configured using the 6-position dip switch (located on the front of each unit) according to the tables on page 8 (1 & 2).

Cascaded Installation

Configure each dip switch as per the tables on page 8 before proceeding.

b. Using the 15HD video cable ends of a USBVEXT-xx-MM cable, connect the

USB Wizard slave's MONITOR port to the master’s

VIDEO 1 port.
c.

Using the USB ends of the same USBVEXT-xx-MM cable, connect one of the USB slave’s USB DEVICES ports to the

master’s CPU 1 port.

Note: Only one of the two ports labeled DEVICES on a slave needs to be used in order for cascading to work.

d. Repeat step b. & c. for each additional slave, keeping in mind that each slave will connect to the next available master’s
    port (i.e. Slave #2 to master’s VIDEO 2 & CPU 2, etc.)   See Fig. 7 on page 8.
e.   With a RMT extension cable, connect the master’s DAISY OUT port to slave #2’s DAISY IN port.   Then connect slave #2’s
    DAISY OUT to slave #3's DAISY IN.    Continue until all slaves are connected together.

Figure 6- Connections for Cascading

CASCADING

( s l a v e u n i t 1 )

( s l a v e u n i t 2 )

( s l a v e u n i t 3 )

( m a s t e r u n i t )

R E X T - S R - x x

U S B - V E X T - x x M M

U S B V E X T - x x - M M

U S B

C P U

U S B

C P U

U S B

C P U

U S B

C P U

U S B

C P U

U S B

C P U

U S B

C P U

U S B

C P U

U S B V E X T - x x - M M

U S B V E X T - x x - M

U S B V

E X T - x

x - M M

U S B - V E X T - x x M M

USB Wizard