BMW 2006 550i Sedan Manual Do Proprietário
Replacing components
212
Lamps and bulbs
Lamps and bulbs make an essential contribu-
tion to vehicle safety. You must be duly diligent
in replacing them. BMW recommends having
your BMW center perform any work that you do
not feel competent to perform yourself or that is
not described here.
tion to vehicle safety. You must be duly diligent
in replacing them. BMW recommends having
your BMW center perform any work that you do
not feel competent to perform yourself or that is
not described here.
Never touch the glass of new bulbs with
your bare fingers, as even minute
your bare fingers, as even minute
amounts of contamination will burn into the
bulb's surface and reduce its service life. Use a
clean cloth, napkin, etc., or hold the bulb by its
metal socket.
bulb's surface and reduce its service life. Use a
clean cloth, napkin, etc., or hold the bulb by its
metal socket.
<
A selection of replacement bulbs is available at
your BMW center.
your BMW center.
Whenever you perform any work on the
electrical system, turn off the consumers
electrical system, turn off the consumers
involved to prevent short circuits from occur-
ring. To avoid possible injury or equipment
damage when replacing bulbs, observe any
instructions provided by the bulb manufac-
turer.
ring. To avoid possible injury or equipment
damage when replacing bulbs, observe any
instructions provided by the bulb manufac-
turer.
<
For care and maintenance of the headlamps,
please follow the instructions in the separate
Caring for your vehicle brochure.
please follow the instructions in the separate
Caring for your vehicle brochure.
For bulbs for which changing is not
described, and for checking and adjusting
described, and for checking and adjusting
headlamp aim, please contact your BMW cen-
ter.
ter.
<
Light-emitting diodes LEDs
Light-emitting diodes installed behind translu-
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.
Do not remove the covers, and never
stare into the unfiltered light for several
stare into the unfiltered light for several
hours, as irritation of the retina could result.
<
Halogen headlamps
The illustration shows the left-hand side of the
engine compartment.
engine compartment.
1 Cover cap for low beams
2 Cover cap for high beams
Turn the cover cap to the left and remove.
2 Cover cap for high beams
Turn the cover cap to the left and remove.
Always wear gloves and eye protection –
the atmosphere within the H7 bulb is
the atmosphere within the H7 bulb is
pressurized. Otherwise there is a danger of inju-
ries if the bulb is accidentally damaged during
replacement.
ries if the bulb is accidentally damaged during
replacement.
<
Low beams
H7 bulb, 55 watts
1.
Turn the bulb holder to the left and remove.
2.
Remove and replace the bulb.
High beams
H7 bulb, 55 watts
1.
Turn the bulb holder to the left and remove.
Online Edition for Part No. 01 41 0 012 211 - © 02/06 BMW AG