BMW 2004 X5 4.8is SAV Manual Do Proprietário

Overview

Controls

Maintenance

Repairs

Data

Index

Starting engine

Switching off engine

When starting the engine, do not press
the accelerator pedal.

X5 3.0i:
Do not actuate the starter for too

short a time. Do not turn it for more
than approx. 20 seconds. Release the
ignition key immediately as soon as the
engine starts.
X5 4.4i, 4.8is:
Your BMW is equipped with the conve-
nience starting feature. Here, it is suffi-
cient to turn the ignition key only briefly
to position 3 'Start engine' and to let go
of it right away. The starter actuation
continues to operate automatically for a
certain period of time and is stopped
automatically as soon as the engine has
started.
The automatic starting mode will not
operate or will be canceled if the bat-
tery voltage is insufficient. The engine
can be started by jump-starting, refer to
page

171

Do not allow the engine to warm up
by leaving it running while the vehicle
remains stationary. Instead, begin to
drive immediately at a moderate engine
speed.

Should the engine fail to start on the
first attempt, if it is very hot or cold, for
instance:

Press the accelerator pedal halfway
down while engaging the starter.

Cold starts at altitudes above 3,300 ft/
1,000 meters and at very low tempera-
tures, from approx. +5 7/–156:

For the initial starting attempt, allow
the starter to remain engaged some-
what longer, approx. 10 seconds.

Engine idle speed is controlled by the
engine computer system. Increased
speeds at startup are normal and
should decrease as the engine warms
up. If engine speed does not decrease,
service is required.

To prevent the battery from discharg-
ing, always switch off electrical devices
that are not in use. Switch the ignition
off when the vehicle is not being driven.

Extended starting attempts, char-
acterized by excessively frequent

or long periods with the starter
engaged, can lead to damage of the
catalytic converter.

Manual transmission:

1. Turn the ignition key to position 1

or 0

2. Engage first gear or reverse gear.

Automatic transmission:

1. Engage selector-lever position P
2. Turn the ignition key to position 1

or 0.

Do not remove the ignition key
when the vehicle is moving, as

otherwise the steering could lock.
When leaving the vehicle, always
remove the ignition key and lock the
steering.
Vehicles with manual transmission:
Always engage the handbrake when
parking on slopes and inclined sur-
faces. Even placing the gearshift lever
in 1st gear or reverse may not provide
adequate resistance to rolling.
Vehicles with automatic transmission:
Place the selector lever in Park.

Vehicles with automatic transmission:

The vehicle must be stationary and the
selector lever in Park before you can
remove the ignition key.