Monogram ZGU486NDPSS Instrução De Instalação

•Slide the rangetop into the opening. Make sure 

the rangetop is evenly seated and supported. 

•A hold-down strap with screws is provided to

secure the rangetop to the rear or side cabinet
walls.

•Remove the hold-down strap from the back 

of the rangetop. Attach one end of the strap 
to the back of the rangetop.

•Secure the other end of the strap as high as

possible to the cabinet back wall or adjacent
cabinet. Keep the strap as short as possible for
better security.

Do not use a flame to check for gas leaks.

A manual shut-off valve must be installed where 
it will be accessible. 

•Install the supplied pressure regulator onto the end 

of the gas inlet.

•You can install a 90° elbow (not provided) onto the 

gas inlet and route the gas connections to avoid
interference with drawers or other cabinetry
features. However, it is not recommended because 
it will result in a drop in gas pressure.

•Make sure the regulator is installed in the right 

direction. See arrow on the underside of the
regulator.

NOTE: Instead of using solid piping to connect 
to pressure regulator, an approved flexible metal
appliance connector may be used between the pipe
stub and the shut-off valve to the pressure regulator, 
if local codes permit.

•Turn on gas and check for leaks:

–Use a liquid leak detector at all joints and

connections in the system.

IMPORTANT: Disconnect the rangetop and the
individual shut-off valve from the gas supply piping
system during any pressure testing of that system 
at test pressures greater than 1/2 psig. Isolate 
the rangetop from the gas supply piping system 
by closing the individual manual shut-off valve
to the rangetop during any pressure testing 
of the gas supply piping system at test pressures
equal to or less than 1/2 psig.

Regulator
(Supplied)

Note: Pipe stub extends
about 1” below burner
box.

Solid Piping
or Flexible
Connector

Shut-Off
Valve

Pipe Stub From
House Gas Supply

Rangetop Burner Box

1/2” N.P.T.
Gas Inlet

Back Wall

Hold-Down
Strap
Location and
Attachment