Monogram ZGU486NDPSS Instrução De Instalação
POWER SUPPLY LOCATIONS
Gas Supply:
• The natural gas models are designed to operate at 5"
water column pressure. For proper operation, the
pressure of the natural gas supplied to the regulator
must be between 7" and 13" water column.
pressure of the natural gas supplied to the regulator
must be between 7" and 13" water column.
• The LP models are designed to operate at 10" water
column pressure. For proper operation, the pressure
of the LP gas supplied to the regulator must be between
11" and 13" water column.
of the LP gas supplied to the regulator must be between
11" and 13" water column.
• Locate the pipe stub on the back wall or floor
(see “Product Dimensions and Clearances”). Use 5-foot
maximum length, 5/8" O.D. flexible gas supply line
(3-foot in Massachusetts).
maximum length, 5/8" O.D. flexible gas supply line
(3-foot in Massachusetts).
• Install a manual shut-off valve in the gas line
(not provided), in an easily accessible location. Make sure
the homeowner knows where and how to shut off the gas
supply to the rangetop.
the homeowner knows where and how to shut off the gas
supply to the rangetop.
Electric Supply:
These rangetops must be supplied with 120 volt, 60 Hz.,
and connected to a dedicated, properly grounded branch
circuit protected by a 15 amp circuit breaker or time
delay fuse.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a standard
three-prong grounding wall receptacle to minimize the
possibility of shock hazard from this appliance.
If the electrical service provided does not meet the above
specifications, it is recommended that a licensed electrician
install an approved outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN EXTENSION
CORD WITH THIS APPLIANCE.
• Locate the electric supply
and connected to a dedicated, properly grounded branch
circuit protected by a 15 amp circuit breaker or time
delay fuse.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a standard
three-prong grounding wall receptacle to minimize the
possibility of shock hazard from this appliance.
If the electrical service provided does not meet the above
specifications, it is recommended that a licensed electrician
install an approved outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN EXTENSION
CORD WITH THIS APPLIANCE.
• Locate the electric supply
within the area shown or within reach of the rangetop’s
four-foot power cord.
four-foot power cord.
• To avoid tangling cord with items stored in the cabinet,
locate the receptacle on rear wall, inside the cabinet.
7
Installation Preparation
MATERIALS PROVIDED
Regulator
Hold-Down
Strap
TOOLS REQUIRED
Adjustable Wrench
1/4" Driver or Wrench
Safety Glasses
Drill and
Appropriate Bits
Measuring Tape
Phillips #2 Screwdriver
Saber Saw
Carpenter’s Square
MATERIALS REQUIRED (not provided)
Shut Off Valve
Pipe Fittings
5-foot maximum length, 5/8" O.D. CSA-approved
flexible metal gas supply
(3-foot maximum length in Massachusetts only)
NOTE: Purchase new flexible line; do not use
previously used flexible gas line.
Joint
Sealant
Level
Hand Truck