Monogram ZV48RSFSS Instrução De Instalação

• To remove the filters, grasp the latch, pull the filter

up  and lift out.

• Drop grease tray into the hood. The rear tabs should

engage the slots in the hood track.

INSTALL BACKGUARD:
• Remove packaging.
• Place backguard against the bottom of the hood to

use as a template. Mark upper screw locations “A”
and “B”

• Remove backguard.
• Drill four 1/8" pilot holes at screw locations “A”

and “B”.

• If drill did not enter studs, enlarge holes to 3/8".
• Insert wall anchors into the enlarged holes. Remove

screws from wall anchors.

• Align and secure backguard to wall using 2 wall

anchor screws or wood screws in locations “A”.

• For 30" and 36" models, install 2 screws through

hole locations “C” at the bottom of the backguard.
For 48" models, install 4 screws.

INSTALL SHELF OVER BACKGUARD:
• Install two shoulder screws into holes “D” in the

bottom of hood flange leaving 1/8" gap.

• Remove shelf packaging and protective film.
• Engage shoulder screws into the keyhole slots in the

top of the shelf. Slide shelf towards the left to lock
into place.

• Install two 3/4" long machine screws through the

bottom of the shelf into the bottom hood flange,
location “E”.

• Install anchor screws through the shelf and into the

wall holes “B”.

• Remove all protective film.

• If installing the backguard alone, without the

shelf, drive screws in all locations shown.

1/8"

Gap

D

B

E

D

E

B

Mounting

Holes for

Backguard (A, C)

and Shelf (B)

C

BACKG

UARD

A

A

B

B

• Insert the filter into the opening and drop into the

bottom. Raise filter to the top and lock into place.