Monogram ZV48RSFSS Instrução De Instalação

• Remove packages from the “V” shaped cardboard

section. Remove shipping pads.

• Lift the hood out of the box.

 Lift the hood by grasping

the outside edges of the exhaust opening on the top.

• The vent hood motor is shipped secured to the skid with

4 screws. Locate and remove 2 screws on each side of the
motor. Discard the shipping skid and screws.

• Grease filters must be removed. Grasp the latch, pull

the filter up and lift out.

Hood

Parts

Wood

Mounting

Support

Motor

Mounted

on Skid

Shipping Carton

Duct

Transition

• From the inside of the hood, loosen (do not remove)

the 2 screws holding the wood mounting support to
the back of the hood. The screws should be backed
out of the wood to 1/4". Remove and set aside the
mounting support with screws for later installation.
DO NOT DISCARD.

• Remove tape and packing material from the hood and

all supplied parts.

• Lift to remove the grease trays. Set grease filters and

trays aside for later installation. DO NOT DISCARD.

Pencil and tape measure

Pliers

Electric or battery operated drill
and 1/8", 3/8" bits

120V 60Hz. 15 or 20 Amp,
2-wire with ground. Properly
grounded branch circuit.

Key Hole Saw

Hammer

Wire cutter/stripper

Step ladder

Metal Snips

Saber saw
or Sawsall

Wire nuts

Phillips and flat

blade

screwdrdivers

Strain relief for
junction cover.

Spirit level

1/4" pivoting

hex socket

Flashlight

Safety glasses

10" round metal
duct, length to
suit installation.

Duct tape