Vinotemp VTREFOUT15 Manual Do Proprietário

 
Before Using Your Unit 

•  Remove all packing material before using your refrigerator.  
•  Check to be sure the appliance is in good condition and that you have all of the following 

parts: 

o

  3 chrome-plated wire shelves 

o

  1 wire basket 

o

  1 instruction manual 

•  Use a soft, dry cloth to wipe down the outside of the refrigerator thoroughly. Clean the 

interior surface with a soft cloth and lukewarm water.  

IMPORTANT: Before connecting the unit to a power source, let it stand upright for 
approximately 24 hours. This will reduce the possibility of malfunction in the cooling system 
from handling during transportation. 
 

•  Position the refrigerator in a dry and well-ventilated place. Avoid placing the refrigerator near 

any source of heat or moisture, or in direct sunlight. The recommended ambient 
temperature should be between 25° and 100°F. 

•  The refrigerator is designed to be free-standing or built-in. The bottom front vent of the unit 

should be free of obstruction.  

•  Place your refrigerator on a solid, level surface (other than carpet). This will ensure vibration 

and noise-free operation. 

•  When positioning the refrigerator, leave a minimum clearance of ½ an inch at the back of 

the unit, 1 inch at the top of the unit and ¼ inch on both sides. This is to ensure proper 
circulation.  

NOTE: Upon plugging the refrigerator into an electrical outlet, let the unit run for at least 30 
minutes before making any adjustments.   
 

Four casters are provided with the refrigerator. They are ideal for rolling the unit from place to 
place outdoors. Use two or more people when installing or removing casters or legs. 
 

1.  Tip unit to the right so there is a ¾-foot clearance at the left of the unit. 

2.  Remove the leveling legs, and tighten one of the casters with lock in the front screw 

hole and tighten one of the casters without lock in the back screw hole. 

3.  Repeat the two steps above with the exception of tipping the unit to the left now, to 

tighten the other two casters. The casters are now installed.  

4.  The unit should be level. If the floor conditions do not allow the unit to sit level, adjust 

the wheel by turning it counter-clockwise to increase the height and clockwise to 
reduce the height.  

7 

 

1 7 6 2 1   S o u t h   S u s a n a   R o a d ,   R a n c h o   D o m i n g u e z ,   C a l i f o r n i a   9 0 2 2 1  

i n f o @ v i n o t e m p . c o m