Monogram ZEU30RSJSS Utilização E Cuidado

Using Your Cooktop

1.  Press and hold All Off pad for 3 seconds, then 

immediately press and hold the Timer Select
pad for 3 seconds to enter custom settings. 
Those two pads must be pressed within 30 
seconds. Any other pad will cancel mode.

2.  “C - -” appears on display. To navigate through 

the Custom Settings, use the ೸ (up) or V (down) 

pads. If ೸ (up) is selected the display cycle 

starts at “C01”. If V (down) is selected, the 
display cycle starts at “C62”.

3.  To activate a new Custom Setting the user will 

touch and hold the Timer Select pad for 3 sec. 
Only ONE of the Custom Setting Choices can 
be activated for each Custom Setting. The red 
“On” LED will turn on and a sound will go off 
once a new custom setting is activated.

4.  The cooktop will exit Custom Settings if it is 

inactive for 3 minutes.

5.  To exit Custom Settings and save any changes, 

touch and hold the All Off pad for 3 seconds.

C01 - Factory Reset (Clears customized settings and restores defaults)

C02 - Custom settings activated (Not visible unless any other custom setting is selected. And 
automatically on when any other custom setting is selected. Not selectable by user.)

C11 - Standard Lock (ie; Only on when lock button pressed for 3 seconds.) If using a timer, 
Control Lock is unavailable.

C12 - Auto Lock (ie; Engages after cooktop has been in standby mode for 10 minutes.) The 
unit should be completely off to go into Auto Lock.

C21 - Full illumination

C22 - Medium illumination

C23 - Lowest illumination

C31 - All sounds activated at 100% (For alarm sounds, 100% = Whatever level is set in c4.)

C32 - Button sound level reduced by 50%, Alarm sounds at 100%

C33 - Button sounds deactivated, Alarm sounds activated at 100%

C41 - High

C42 - Low

C51 - Indefinite (ie; alarm continues until cancelled by user).

C52 - Alarm sounds for 60 seconds.

C53 - Alarm sounds for 30 seconds.

C54 - Alarm sounds for 15 seconds.

C61 - Single Kitchen Time (Independent of elements.)

C62 - Multi-Timer (Tied to each element.)

* Options in grey are default settings

16