Vinotemp VT36 Manual Do Proprietário

 
BEFORE USING YOUR APPLIANCE 

 
•  Remove the exterior and interior packaging. 
•  Before connecting the appliance to the power source, let it stand upright for approximately 2 

hours. This will reduce the possibility of a malfunction in the cooling system from handling during 
transportation. 

•  Clean the interior surface with lukewarm water using a soft cloth. 
•  Install the handle on the door. 
 

 
•  Use two or more people to move and install the appliance. Failure to do so can result in back or 

other injury. 

•  Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. 

•  Choose a well-ventilated area with temperatures above 60°F and below 90°F. 

•  This appliance is designed for built-in, recessed or free standing installation. 

•  For built-in installation, leave a ¼” (6.35mm) space on each side and at the top of the wine cooler 

to ensure proper air circulation to cool the compressor and condenser.  

• 

Even for built-in installation, you must keep space on each side and at the top. If you plan to use 
the unit for a built-in application please follow  the requirements shown below:

Cabinet Opening Dimensions (minimum) 

Width 24” 

Depth 25” 

Height 33” 

•  The appliance must be installed with all electrical, water and drain connections in accordance with 

state and local codes. 

• 

Make certain that the pipes are not pinched, kinked or damaged during installation. Check for 
leaks after connection.

 

 

NOTE: Designed for indoor, home use only. The appliance should not be located next to sources 
of high heat or in direct sunlight. Do not store or install the appliance outdoor, garage, basement or 
in moist areas. Don’t install in a location where the temperature will fall below 50°F. For best 
performance and to ensure proper ventilation, do not install the appliance behind a cabinet door or 
block the base grille. 

 
•  It is important for the appliance to be leveled in order to work properly. You may need to make 

several adjustments to level it. 

•  To level your appliance, adjust the front legs at the bottom of the appliance. 

•  When positioning the wine cooler, ensure that there is at least a ¼ inch clearance at the sides and 

a 1 inch clearance at the back of the cooler as this is the main outlet for heat. This will allow for 
adequate ventilation. 

 

9 

 

1 7 6 2 1   S o u t h   S u s a n a   R o a d ,   R a n c h o   D o m i n g u e z ,   C a l i f o r n i a   9 0 2 2 1  

i n f o @ v i n o t e m p . c o m