Vigo Industries VGT493 Guia De Especificação

4

68031

Set Screw

68040

Aerator Ring

Cartridge Nut

Handle

68039

W

Aerator

Sedal Cartridge

68037

64014

64016

BN,CH,ARB

Supply Hose

74020

BN,CH,ARB

PARTS LIST - 

For any parts needed but not shown, please contact Vigo Technical Support

PART

TOLL FREE: (866) 591 - 7792

E-Mail: techmail@vigoindustries.com

www.vigoindustries.com

PART #

FINISH

SUPPLY DATE INDICATOR (INTERNAL USE ONLY)

W
W
W
W
W
W

TROUBLESHOOTING

PROBLEM

POTENTIAL CAUSE

CORRECTIVE ACTION

1 - Leaks from handle

2 - Insufficient flow rate

3 - Leak at connection points

4 - Loose faucet body

1.A - Cartridge unseated
1.B - Cartridge defective

2.A - Dirty aerator
2.B - Clog in supply hose / line

3.A - Flexible hose leaking at connection point
3.B - Washer defective

4. - Mounting hardware became loose

3.A - Tighten hoses. If this does not resolve the issue, remove
the flexible hose and rethread, checking to make sure the
connection is secure. Make sure to use pipe tape.

2.B - Remove supply lines and flush lines.

2.A - Remove aerator and soak / clean with a non abrasive
agent (i.e. half hot water and half vinegar).

1.B - Contact Vigo Technical Support for replacement.

1.A - Remove cartridge from housing, wash thoroughly with hot

water and reseat in housing.

3.B - Remove supply line and check the status of the washer. If
torn, washer must be replaced for a secure, non-leaking
connection.

4. - From under the counter, use an adjustable wrench and
tighten the mounting hardware. Make sure the faucet is
perpendicular to the counter.

5 - Loose handle

5. - Set screw has become loose

5. - Take off hot/cold cover on handle. This will give you access
to the screw that connects the handle to the cartridge. Using
either an allen key or a flat head screw driver, tighten the screw
so handle has firm connection to cartridge.

2.C - Clog in copper supply pins

2.C - Remove copper pins and flush/clean out.

NSF / ANSI 61