Moen YB0824CH Ficha De Características
2 5 3 0 0 A L M O E N D R I V E
N O R T H O L M S T E D , O H 4 4 0 7 0
C O R P O R A T E H E A D Q U A R T E R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9
F A X : ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N T E R N A T I O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0
F A X : ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S T O M E R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6
F A X : ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . M O E N . C O M
Copyright Creative Specialties International
Literature #BA1719
Towel bar posts are constructed of
zinc. Bar is constructed of brass.
zinc. Bar is constructed of brass.
YB0818BN
– 18” Towel Bar
Brushed Nickel Finish
YB0818CH
– 18” Towel Bar
Chrome Finish
YB0824BN
– 24” Towel Bar
Brushed Nickel Finish
YB0824CH
– 24” Towel Bar
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Towel Bar
By Creative Specialties
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
YB0818 & YB0824
Arris
TM
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
1) Position the mounting template on the wall in the desired location.
2) Using a level, align the template and tape it to the wall.
3)
2) Using a level, align the template and tape it to the wall.
3)
Drill two ¼” holes at each mounting post location that corresponds to
your product.
4) Remove the template from the wall.
5) Disassemble screws and washers from anchors.
6) Lightly tap anchors until flush with the wall.
7) Remove mounting posts from the product assemblies by loosening
5) Disassemble screws and washers from anchors.
6) Lightly tap anchors until flush with the wall.
7) Remove mounting posts from the product assemblies by loosening
each setscrew.
8)
One at a time, place each mounting plate over anchors (with “UP”
facing you) and insert screw and washer through plate into anchor.
9) Tighten screws until anchor is activated behind wall (approximately
45 turns) and tight.
10) Position each end post with setscrews facing down and place over
both mounting posts. Tighten the setscrew at the bottom of each
post.
post.