Whirlpool WEG760H0DH Instrução De Instalação

1. Place level on the oven bottom, as indicated in one of the two 

figures below, depending on the size of the level. Check with 
the level side to side and front to back.

2. If range is not level, use a wrench or pliers to adjust leveling 

legs up or down until the range is level.

NOTE: Range must be level for satisfactory baking 
performance and best cleaning results using AquaLift

®

 

Self-Clean Technology.

This range is factory-set for use with Natural gas. To use this 
range with LP gas, see the “Gas Conversions” section before 
connecting this range to the gas supply. Gas conversions from 
Natural gas to LP gas or from LP gas to Natural gas must be 
done by a qualified installer.

1. Apply pipe-joint compound made for use with LP gas to the 

smaller thread ends of the flexible connector adapters. See B 
and G in the following illustration. 

2. Attach one adapter to the gas pressure regulator and the 

other adapter to the gas shutoff valve. Tighten both adapters, 
being certain not to move or turn the gas pressure regulator.

3. Use a 

¹⁵⁄₁₆" (2.4 cm) combination wrench and an adjustable 

wrench to attach the flexible connector to the adapters.

IMPORTANT: All connections must be wrench-tightened. Do 
not make connections to the gas regulator too tight. Making 
the connections too tight may crack the regulator and cause 
a gas leak. Do not allow the regulator to turn when tightening 
fittings. 

1. Check that the gas pressure regulator shutoff valve is in the 

“on” position.

2. Open the manual shutoff valve in the gas supply line. The 

valve is open when the handle is parallel to the gas pipe.

3. Test all connections by brushing on an approved 

noncorrosive leak-detection solution. If bubbles appear, a 
leak is indicated. Correct any leak found.

A

B

C

D

E

F

G

H

A

A

B