Maytag UXT2030AD Instrução De Instalação

5. Mark Hole Locations 

Lift the range hood into place and insert the mounting bracket 
tabs through the slots in the back of the range hood. 

Hold the range hood firmly in place with one hand and bend each 
mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

Mark the 4 vent hole locations (C) on the top of the range hood.
OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

6. Mark and Cut Vent Opening 

■

Using the 7" (17.8 cm) round vent mounting plate, draw the 
vent opening outline on the underside of the cabinet:

-

Place the vent mounting plate on the bottom of the 
cabinet. Position the edge of the plate with the widest 
distance (A) between the hole and edge of the mounting 
plate against the wall. Position the side edges of the 
mounting plate between the dots marked previously.

IMPORTANT: The widest edge (A) of the vent mounting 
plate must be positioned against the wall.

-

Trace the 7" (17.8 cm) vent opening (solid line) on the 
cabinet bottom.

■

Using a jigsaw or keyhole saw, cut the vent opening 1" 
(2.5 cm) larger than the 7" (17.8 cm) hole traced (dashed line).

7. Drill Electrical Opening

Using a 1

¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked 

previously at the electrical strain relief.

OPTIONAL: Using a 

¹⁄₈" (3 mm) drill bit, drill pilot holes for the 

dots marked previously at each mounting tab at an approximate 
45° angle in an upward direction.

C

B

A

C

A

90˚

A