Whirlpool WGE555S0BB Instrução De Instalação

2. Use 

³⁄₈" nut driver to connect the neutral (white) wire to the 

center terminal block post with one of the 10-32 hex nuts.

3. Connect line 1 (black) and line 2 (red) wires to the outer terminal 

block posts with 10-32 hex nuts.

4. Securely tighten hex nuts.

NOTE: For power supply cord replacement, only use a power 
cord rated at 250 volts minimum, 40 amps or 50 amps that is 
marked for use with nominal 1

³⁄₈" (3.5 cm) diameter connection 

opening, with ring terminals and marked for use with ranges.

5. Replace terminal block access cover.

This range may be connected directly to the fuse disconnect or 
circuit breaker box. Depending on your electrical supply, make the 
required 3-wire or 4-wire connection.
1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip the 

insulation back 1" (2.5 cm) from the end of each wire.

2. Allow enough slack in the wire to easily attach the wiring 

terminal block.

3. Complete electrical connection according to your type of 

electrical supply (4-wire or 3-wire connection).

Use this method for:

■

New branch-circuit installations (1996 NEC)

■

Mobile homes 

■

Recreational vehicles

■

In an area where local codes prohibit grounding through the 
neutral

1. Part of metal ground strap must be cut out and removed.

2. Use Phillips screwdriver to remove the ground-link screw from 

the back of the range. Save the ground-link screw and the end 
of the ground link under the screw.

3. Pull the conduit through the strain relief on cord/conduit plate 

on bottom of range. Allow enough slack to easily attach wiring 
to the terminal block.

A

B

C

D

E

A

B

C

A

B

C

D

E

F

G