Marvel M36SS Instrução De Instalação

10

Figure 9

Figure 8

-Wall stud

-Anti - tip

bracket 

on top of 

cabinet

-At least 2 

screws into 

wall stud.

Crosswise

lumber-

-Leave 

access for 

water line if 

required.

When planning your rough in opening a 3" (7.6cm) re-

movable filler panel is recommended above the grille. To 

remove the power module from the cabinet the front has to 

be tilted up as shown in Figure 7 when removed for service.

Figure 7

-3" (7.6cm) removable filler 

recommended

84

5

⁄

8

"

(214.9cm)

Maximum

Before placing the cabinet in opening, the depth of the 

cut-out opening should be at least 24" (61cm). If the cut-out 

opening depth is more than 24" (61cm), then a piece of 

wood must be secured crosswise on the wall into the studs 

at the height of the anti-tip brackets. (See Figure 9). Slide 

the cabinet into position and level the cabinet with adjust-

able rear roller and front leveling legs. (See Leveling the 

unit on page 11). 

Locate a wall stud behind the unit that is suitable for secur-

ing the 5” (12.7cm) anti-tip bracket to the wall. The position 

of the bracket should be to the right of the power module 

and not behind the power module. Do not disturb the power 

module gasket on the left side of the unit. Place the anti 

tip bracket on top of the cabinet flush with the back of the 

cabinet. Mark and drill at least three holes (

1

⁄

8

” (3.2mm) into 

the top of the cabinet and secure the bracket to the top of 

the cabinet with at least (3) of the #8 x 

5

⁄

8

” screws provided. 

Secure the bracket to the wall stud with at least (2) #8 x 

1

1

⁄

2

” screws provided. See Figure 8.