Dacor RNRP30G Instrução De Instalação
STEP 1 Disconnect the range power supply at the
circuit breaker or fuse box. Turn the gas
OFF at the gas supply valve.
STEP 2 Remove the range grates.
STEP 3 Remove and discard the screws from the
STEP 3 Remove and discard the screws from the
rear of the backguard.
STEP 4 Position and hold the kit against the rear of
the backguard.
STEP 5 Thread the new screws through the kit and
into the backguard. Screw them firmly into
place.
STEP 6 Finish installing the downdraft and slide
the range into position.
STEP 7 Re-engage the range within the anti-tip
bracket.
STEP 8 Connect the power to the circuit breaker
or fuse box.
STEP 9 Turn the gas supply valve ON.
• Make sure the downdraft is in place before sliding the range into position.
• Confirm that the range’s anti-tip bracket is re-engaged when the final project is complete.
Part No. 109308 Rev. A
Trim Kit #
ATKERV-RP30
Parts included with this kit:
DANGER:
Electric shock and explosion hazard! Before installation:
● turn the power OFF at the circuit breaker or fuse box, and
● turn the gas supply valve OFF.
WARNING: Do not maneuver or handle the range unless it is cool.
Instructions
RNRP30G Range
Shown
Kit Installation on Backguard
backguard
range
range
Hardware Kit #
101307-21
Trim Kit for RNRP30G Range with
3-inch High Backguard + ERV Downdraft
INSTALLATION
INSTRUCTIONS
ATKERV-RP30