Thermador SGS305FS Guia Do Utilizador

English 8

Thermador® ExtraLow (XLO) Burners 
(SGSX Models only)

The center and left front burners are enhanced with the 
ExtraLow (XLO®) feature. When the control knob is set 
within the XLO® zone, the flame cycles OFF and ON 
automatically for varying seconds every minute. This 
cycling is normal and allows you to reduce the heat even 
further than the low setting to cook delicate foods. For 
example, this very low setting is suitable to simmer, poach, 
melt or hold cooked food without scorching or burning.

•

The burner flame will cycle ON and OFF during each 
minute when the setting is at any position between LO 
(past detent) and XLO.

•

The length of time the flame is ON and OFF depends 
on the knob setting.

•

With a setting just below LO, the flame will be ON 
approximately 53 seconds and OFF 7 seconds of each 
minute.

•

With a setting at the XLO position, the flame is ON 
approximately 7 seconds and OFF 53 seconds of each 
minute.

•

The knob can be set to any position between LO and 
XLO.

Do not clean or touch any of the burners when 
one or both ExtraLow burners are in use. When 
the ExtraLow burner automatically reignites, the 
igniter at the burner will spark.

Burner “ON” Lights

For SGS models: 
An “On” light corresponds with the knob for each burner. 
When illuminated, it indicates that the corresponding 
burner is in use.

For SGSX models:
A light ring around each knob will illuminate to indicate that 
the corresponding burner is in use.

Burner Grates

Grates must be properly positioned before cooking.

To prevent flare-ups, properly support pots, and 
avoid spills, all grates must be properly 
positioned on the cooktop whenever the 
cooktop is in use. Each of the four feet must be 
placed into the corresponding dimples in the 
cooktop. Do not use a grate if the rubber feet 
are missing or damaged.

For replacement rubber feet: Part # 416438, contact your 
dealer or call the service number listed inside the cover.