Monogram ZV830SMSS Instrução De Instalação

If house wiring is not 2-wire 

with a ground wire, a ground must be provided by
the installer. When house wiring is aluminum, be
sure to use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.

• Remove the 6 screws on the junction box cover 

and the knockout on the top or left side. 

• Secure the house wiring to the junction box with 

a strain relief.

• Connect the white lead to the branch circuit white lead.
• Connect the black lead to the branch circuit black lead.
• Connect the green/yellow lead to the branch

circuit green lead or bare ground lead.

• Secure all the connections with wire nuts on each

electrical connector.

• Push the wires into the junction box and replace 

the cover. Be sure the wires are not pinched.

• Secure the junction box cover with the 6 original

screws.

Junction

box cover

• Remove protective plastic

covering.

• Place the decorative duct

covers on top of the hood.

NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed
for recirculating purposes. Be
sure the vented end is at the top;
the vent holes will be visible in
this installation.

The inside duct piece must slip 
into the folded ends on the outer section.

• Extend the inner duct upward to the ceiling

bracket.

• Press up on the front corners of the filter cover panel

to unlock. Lower the panel to access the filter.

• Locate the screw holes on the inside front edge 

of the opening. Install 2 screws to secure the duct
cover to the hood.

Mounting

screws

Vent holes

Lower duct
cover seat

Duct cover

support bracket

Lower duct
cover

Upper
duct cover

Duct attachment

tabs

Screw holes