Dacor RNRP30GCLP Instrução De Instalação

Installation Instructions

Removing the Oven Door

• 

Do not attempt to disengage the hinge catches with the 

door(s) removed from the range. The hinge springs could 

release causing personal injury.

• 

Do not lift or carry the oven door(s) by the handle.

NOTE: When installing a backguard, always install it before sliding 

the range into place. See page 7.
To make the range easier to move, remove the door(s) to reduce 

weight.
1.  Open the door until its lying completely open and flat.
2.  Use a pair of needle nose pliers and a flat blade screwdriver 

to rotate the catch over the retaining arm on each hinge (see 

Oven Door Hinge)

3.  Close the oven door three-quarters shut (see below).
4.  Grasp each side of the door, just below the handle, with both 

hands.

5.  In a single motion, pull the door away from the oven while 

continuing to lift up and out.

Catch

Retaining Arm

Connecting the Gas

•  Make sure the gas supply valve is off and that the power 

cord to the range is disconnected prior to connecting the 

gas line.

•  Do not apply excessive pressure when tightening gas 

connections and fittings.

•  Do not use Teflon tape or plumber’s putty on gas flex line 

connections.

•  For LP installations, the LP gas tank must have its own 

high pressure regulator. This is in addition to the pressure 

regulator provided with the range.

•  The maximum gas supply pressure to the regulator must 

never exceed 1/2 pound per square inch (psi) or 3.5 kPa.

•  The range and shut-off valve must be disconnected from the 

gas supply piping during any pressure testing exceeding 1/2 

psi (3.5 kPa).

•  The range must be isolated from the gas supply piping by 

closing the shut-off valve during any pressure testing at or 

below 1/2 psi (3.5 kPa).

•  Check all gas lines for leaks as instructed to avoid a fire or 

explosion hazard. Do not use a flame to check for leaks.

NOTE: The gas pressure regulator is pre-set at the factory for the 

type of gas intended for use with the appliance. 
To verify that the appliance is compatible with the type of gas 

available, check the range rating label (see inside cover for 

location). Ranges intended for use with LP gas will have “LP” as a 

part of the model number. Consult your dealer if the range is not 

compatible with the type of gas being supplied.

1.  Make sure the gas supply valve is OFF, and power to the 

range is OFF.

2.  Connect a flexible gas supply line to the gas shut-off valve. 

This gas line needs to be long enough to allow the range 

enough distance to be pulled out for service.

3.  Slide the gas line up through the range’s access holes in the 

back of chassis and up to the regulator. Move the wires tht 

are inside the access holes to prevent them from catching on 

the gas line as you maneuver the gas line.

4.  Connect the gas line to the regulator.
5.  Turn all cooktop control valves to OFF.
6.  Turn the gas supply 

ON.

7.  Check all lines and 

connections for 

leaks using a soap 

and water solution.

8.  After verifying that 

there are no gas 

leaks, turn the 

gas supply valve 

connected to the 

range to OFF.

Regulator

Flexible Gas Line