Heartland HCFDR23BLK Manual Do Proprietário

11

If your refrigerator will not fit through an entrance area, 

you can remove the doors. Check first by measuring the 

entrance.

1.  Make sure the electrical power cord is unplugged from 

the wall outlet.

2.  Open the freezer drawer and remove the toe grille (see 

“Installation” section).

3.  Remove any food from the door shelves and close the 

doors.

1.  Remove the two screws from each cover over the top 

door hinges.

2.  Lift inside edge of hinge cover and tilt back.

DO NOT remove the ground screw from hinge.
To remove the refrigerator doors:

1.  Trace lightly around the door’s top hinges with a pencil. 

This makes reinstallation easier.

2.  Disconnect the harness by grasping both sides of the 

connector firmly, depress the latch, and pull apart. Re-

move the two screws from the top hinge. Lift the door 

off of the bottom hinge and set it aside.

3.  Unscrew the three lower hinge screws and hinge if 

necessary.

To reinstall the right door, reverse the above steps.

Once both doors are in place, ensure they are aligned with 

each other and level (please see the “Installation” section 

for more details), and replace the top hinge cover.

Be sure doors are set aside in a secure position where they 

cannot fall and cause personal injury, or damage to the 

doors or handles.

Front

cover screw

Top hinge

cover

Hinge

screws

Rear

cover

screw

Ground

screw

Top

hinge

Multi-wire

cables

Leave

hinge

with

door

Figure 20

Figure 21

Figure 22

Figure 23