Monogram ZV900SLSS Instrução De Instalação
19
Installation Instructions
INSTALLATION—RECIRCULATING
INSTALL FILTERS
IMPORTANT: Check to be sure that the main
ON/OFF switch next to the motor is in the ON
position.
Charcoal filter
ON/OFF switch next to the motor is in the ON
position.
Charcoal filter
• Install the black charcoal filter into the center
opening. Secure the filter with thumbscrews on
each side.
each side.
Metal filter
• Tip the filter into the left or right side of the
opening. Lift the filter to the opposite side and into
the filter lock.
the filter lock.
• To remove the filter, pull the filter lock downward.
10
FINALIZE INSTALLATION
• Remove all tape and packing material.
• Refer to the Owner’s Manual for operating
• Refer to the Owner’s Manual for operating
instructions.
11
INSTALL DUCT COVERS
• Place the decorative duct
covers on top of the hood.
NOTE: The inside piece has
holes on one end intended for
use when the hood is installed
for recirculating purposes.
Be sure the vented end is at
the top; the vent holes will
be visible in this installation.
holes on one end intended for
use when the hood is installed
for recirculating purposes.
Be sure the vented end is at
the top; the vent holes will
be visible in this installation.
The inside duct piece must slip
into the folded ends on the outer
section.
into the folded ends on the outer
section.
• Extend the inner duct upward to the ceiling
bracket.
• Secure duct cover to ceiling bracket with 2 screws.
9
Mounting
screw holes
Vent holes
Duct cover
support bracket
Upper
duct cover
duct cover
Lower duct
cover
cover
Lower duct
cover seat
cover seat
Filter Lock
Duct cover
support bracket