Broan QML30 Instrução De Instalação

Always turn the hood ON before cooking in order to establish an

air flow in the kitchen. After turning off the range, let the hood run

for a few minutes to clear the air.
Operate the hood as follows:

 Turns fan on to LOW speed.

Turns fan OFF.

Turns fan on to HIGH speed.

 Turns light on to LOW intensity.

Turns light OFF.

Turns light on to HIGH intensity.

Proper  maintenance  of  the  Range  Hood  will  assure  proper

performance of the unit.

Motor
The motor is permanently lubricated and never needs oiling. If

the  motor  bearings  make  excessive  or  unusual  noise,  replace

the motor with the exact service motor. The impeller should also

be replaced.

Grease Filter
The  grease  filter  should  be  cleaned  frequently.  Use  a  warm

dishwashing detergent solution. Grease filter is dishwasher safe.
Clean all-metal filters in the dishwasher using a non-phosphate

detergent. Discoloration of the filter may occur if using phosphate

detergents, or as a result of local water conditions - but this will

not affect filter performance. This discoloration is not covered by

the warranty.
See  “INSTALL  FILTERS”  section  for  removal  and  installation

instructions.

Non-ducted Recirculation Filter
The  non-ducted  recirculation  filter  should  be  changed  every  6

months. Replace more often if your cooking style generates extra

grease, such as frying and wok cooking. See Step 15 on page 4,

for removal and installation instructions.

•  Regularly wash with clean cloth or rag soaked with warm water

and mild soap or liquid dish detergent.

•  Always clean in the direction of original polish lines.

•  Always rinse well with clear water (2 or 3 times) after cleaning.

Wipe dry completely.

•  You may also use a specialized household stainless steel cleaner.

•  Use  any  steel  or  stainless  steel  wool  or  any  other  scrapers  to

remove stubborn dirt.

•  Use any harsh or abrasive cleansers.

•  Allow dirt to accumulate.

•  Let  plaster  dust  or  any  other  construction  residues  reach  the

hood.  During  construction/renovation,  cover  the  range  hood  to

make sure no dust sticks to the stainless steel surface.

•  Any cleaners that contain bleach will attack stainless steel.

•  Any  products  containing  chloride,  fluoride,  iodide,  bromide

will deteriorate surfaces rapidly.

•  Any  combustible  products  used  for  cleaning,  such  as

acetone, alcohol, ether, benzol, etc. are highly explosive and

should never be used close to a range.

Use 120 V, 35 W,

Halogen Bulbs - MR16 with GU10 base.

The

Suction Cup Tool (included with hood) can be used to install

and  remove  light  bulbs.  Press  suction  cup  tool  on  to  bulb  and

rotate counterclockwise to remove bulb or clockwise to install bulb.
Align pins on bulb with large diameter opening on socket, then

push bulb in towards hood and rotate clockwise until firmly seated.
The  position  of  the  bulb  socket  (depth)  is  adjustable  and  may

require adjustment when:

 a) certain brands of bulbs are difficult to install.

 b) the bulb protrudes too far below the light panel.

See Step 24 for bracket adjustment detail.

(1)

PUSH IN

(2)

ROTATE

CLOCKWISE

SUCTION

CUP TOOL

HALOGEN

BULB

LIGHT PANEL