Dacor DWD30S Instrução De Instalação

•  Minimum ambient operating temperature: 32°F (0°C).
•  The correct voltage, frequency and amperage must be 

supplied to the electrical outlet from a grounded, single 

phase circuit that is protected by a properly sized circuit 

breaker or time-delay fuse.

•  The required voltage, frequency and amperage ratings 

are listed on the product data label. See page 1 for 

location.

•  The power supply requirements shown above are for 

reference only. If they do not agree with those listed 

on the product data label, use the requirements on the 

product data label. 

•  It is the owner’s responsibility to ensure that the 

electrical outlet is installed by a qualified electrician. 

The electrical installation must comply with the latest 

revision of the National Electric Code ANSI/NFPA 70 

and local codes and ordinances.

•  If the electrical service provided does not meet the 

product specification, or does not conform to the NEC 

or local standards, do not proceed with the installation. 

Call a licensed electrician to correct the electrical 

service before proceeding.

•  Be certain to locate the electrical outlet in an 

accessible location, so that the warming drawer may 

be easily unplugged in the event that service becomes 

necessary.

•  Keep the electrical cord away from hot surfaces.

Installation Specifications

Install Support Platform in 

Cabinet

Provide a platform (100 lb. load capacity) within the cabinet 

upon which the warming drawer will be supported. The 

platform must be installed level and straight. The top edge 

of the platform must be flush with the cutout at the front of 

the cabinet. There are no provisions to level the warming 

drawer after it has been installed. 3/4” (1.9 cm) thick 

plywood is recommended.
NOtE: If the drawer is not installed in a level fashion, the 

drawer may slide open on its own or may not seal tightly, 

allowing heat to escape and resulting in poor warming 

drawer performance.

Support

platform

Chassis

face

Electrical and Environmental 

Specifications

IMPORtANt: This appliance is equipped with a three 

prong grounding electric plug for protection against 

possible electric shock hazards. It must be plugged into 

a dedicated, grounded, electrical outlet. If only a two 

prong electrical outlet is available, it is the responsibility 

of the customer to have it replaced with a dedicated, 

properly grounded three prong electrical outlet. 

•  Cut or remove the third (ground) prong from the power 

cord.

•  Use an adapter plug.
•  Use a power cord that is frayed or damaged.
•  Immerse the power cord or plug in water or other 

liquid.

•  Connect the appliance to an extension cord.
NOtE: Use of a ground fault interrupter (GFI) is not 

recommended.

Nominal Electrical Supply Requirements
120 Vac, 60 Hz, 15 Amp., dedicated circuit
The warming drawer is supplied with a 40” (101.6 cm) 

power cord with a three prong grounded plug.
total Connected Load  0.5 kW (4 Amp.)

Three prong plug

Three prong  

grounded outlet