Monogram ZXD30B Instrução De Instalação

• Lay the custom panel, appearance side down, 

on a clean surface. 

• Place the flat side of the metal panel onto the

back side of the custom panel, with the
mounting flanges facing up.

• Align the lamp hole in the panel with the

mounting panel.

• Check top, bottom and side overlap dimensions

from the metal panel to wood panel edge as
shown.

3/16"

1/4"

7/32"

1/4"

Top

Bottom

Align Holes

Handle

Attachment Holes

Pub. No. 49-8969-2
Dwg. No. 164D3333P196

977-0298-000             06-04 JR

NOTE: Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.

• Separate the custom panel and metal panel.
• Apply a few horizontal beads of adhesive to the

metal panel. Avoid adhesive within 1” of lamp
hole area and outer edges.

3/4” thick panels may be secured to the metal
panel with screws.
• Use the metal panel as a template. Position the

metal panel over the back side of the custom
panel and drill pilot holes. Drill pilot holes sized
to match screws being used (screws not
provided).

Select screw length

carefully to avoid penetration of the finished side.

Turn the assembly appearance side up.
• Use plastic to wood adhesive to secure the lamp

jewel to the front of the wood panel. On the side
with the bulge, (see illustration) apply a small
bead of adhesive around the outside edge. 
Place the jewel into the drilled hole.

Insert 
Jewel

Appearance
Side

This Side
Against 
Wood

A custom handle (not supplied) may be installed.
• Drill pilot holes through the front of the custom

panel and through the metal panel to match the
chosen handle.

NOTE: The handle screws should be installed
through the metal panel, the custom panel and
into the custom or original handle.

• Install the custom panel assembly to the exposed

drawer front using the original 7 screws.

Custom Handle

or Original Handle

Back side of Appearance Panel with Support Panel