Elica ELN136SS Instrução De Instalação

The range hood is designed to remove smoke, cooking vapors and

odors from the cooktop area. For best results, start the hood before 

cooking and allow it to operate several minutes after the cooking is 

complete to clear all smoke and odors from the kitchen.

The hood controls are located on the center side of the range hood.

A

B

A. Lamps knob

B. Blower knob

1.  Turn the light switch to the “LOW” position to turn the range hood 

 

lights On.

2.  Turn the light switch to the “HI” position to turn the range hood 

 

lights at its higher intensity.

3.  Turn the light switch to the “OFF” position to turn the range hood 

 

lights Off. 

1.  Turn the blower switch at “1” to turn the range hood on.

2.  Turn the blower switch to the desired speed position.

3.  Turn the blower switch to the “HI” position to turn the range hood 

 

on High.

4.  Turn the blower switch to the “OFF” position to turn the range 

 

hood blower Off. 

 

Turn off the range hood and allow the halogen lamp to cool. To avoid 

damage or decreasing the life of the new lamp, do not touch lamp 

with bare fingers. Replace lamp, using tissue or wearing cotton gloves 

to handle lamp. If new lights do not operate, make sure the lamps are 

inserted correctly before calling service.

1.  Disconnect power.

2.  Use a flat-blade screwdriver and gently pry the light cover loose. 

3.  Remove the lamp and replace with a 120-volt, 40-watt 

 

maximum, halogen lamp made for a G-9 base.

4.  Replace the light cover.

5.  Reconnect power.

6.  Turn the light switch to the “OFF” position to turn the range hood 

 

lights Off. 

 

To avoid damage to the exterior surface, do not use steel wool or

soap-filled scouring pads. Rub in direction of the grain line to avoid 

scratching the surface.

Always wipe dry to avoid water marks.

 

■

Stainless Steel Cleaner and Polish.

 

■

Mild liquid detergent and water.

 

■

Wipe with damp soft cloth or nonabrasive sponge, then rinse 

 

with clean water and wipe dry.

1.  Use 2 hands to remove filters. 

2.  Grasp filter handles, pull toward the front of range hood and pull 

 

down on the rear handle to remove. Repeat for each filter.

A

A. Grease filter

3.  Remove grease drip tray.

A

A. Drip tray

4.  Wash metal filters and grease trays as needed in dishwasher or 

 

hot detergent solution to clean.

5.  Replace grease drip tray.

6.  Reinstall filters, grasp filter handles and place front edge of filter 

 

into the hood.

7.  Push up on the back handle and set rear of filter into the drip tray 

 

to secure. Repeat for each filter. 

A

A. Grease filter