Dacor RNRP30GSNGH Instrução De Instalação

Installing the Anti-Tip Bracket to the Floor 

1.  Determine the location of the range center line and front 

panel for the range’s final position based on the Product 

Dimensions on page 5 and the actual cabinet / cutout 

dimensions used for the installation.

2.  Determine the placement of the anti-tip bracket, based on the 

diagram below. Mark the four (4) mounting hole locations on 

the floor with a pencil.

3.  Determine the screw size required. The minimum full thread 

depth (portion of screw threaded into wood/slab) for wood is 

3/8” (1 cm) and 5/8” (1.6 cm) for concrete. See 

TABLE to select the correct screw size.

• 

Drill four (4) 3/8” diameter countersink holes through any 

existing floor covering down to the concrete slab below.

• 

Drill four (4) holes for the anchors 1 1/4” (3.2 cm) deep 

into the concrete slab using a 3/16” masonry bit. This hole 

length is longer than the anchor, but is required for proper 

installation. 

• 

Clear the holes of dust and any other material. 

• 

Take a hammer and tap each anchor into the hole until the 

anchor top is flush against the concrete slab. 

• 

Place the anti-tip bracket on top of the anchors.

• 

Position the anti-tip bracket holes over the anchor holes, 

and thread the screws into the anchors. Be sure the screw 

threads fully engage the anchor body. 

• 

Tighten the screws into place.

If there is ceramic, asphalt, or another hard floor covering over 

the wood, drill holes to allow access to the wood below for drilling 

mounting holes.
Use the correct type of drill bit for the surface you will be drilling.
Once you have hit wooden flooring:
• 

Drill four (4) mounting holes into the wood using a drill bit 

(1/16” dia. for #8 screws, 1/8” dia. for #12 screws). 

• 

Position the anti-tip bracket holes over the holes in the floor. 

• 

Insert the screws into the wood and tighten into place.

Installing the Anti-Tip Bracket to the Floor 

To perform its intended function, the anti-tip bracket must be 

attached as instructed to the concrete slab or wood sub-floor 

that is below any floor coverings (including cement board). 
Do not attach the anti-tip bracket directly to floor coverings such 

as ceramic/asphalt tile or linoleum.

Use the anchors and four (4) of the Phillips head screws when 

attaching the anti-tip bracket to a concrete sub-floor.
• 

Four (4) plastic anchors  

• 

1-inch #8 (4)

• 

1 1/4-inch #8 (4)

• 

1 3/4-inch #12 (4) 

Do not use these plastic anchors when attaching to a wooden 

sub-floor.

Installation Instructions

CL

22 1/2” 

Plastic Anchors

Range 

center line

Range front 

panel*

Screws

Mounting Holes

10 7/8”