Dacor DHW361 Guia Do Desenho

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

®

Document # PG07-001

Revised 10/27/14   Page 1/1

Chimney 

24”

(61.0 cm)

Min. 30 1/4” (76.8 cm) Max. 42” (106.7 cm)

30” - 36” - 42” - 48”

15”

(38.1 cm)

11 3/4”

(29.8 cm)

5 3/4”

(14.6 cm)

12 1/2” (31.8 cm)

16 1/4” * (41.3 cm)

Blower

600 CFM* (1200 CFM* for units with 2 blowers) 

with electronic speed control

Blower speeds

4

Lights

12 Vac, 20 Watt halogen

Filters

Baffle type, dishwasher safe

Exhaust

8 inch

Finish

430 stainless steel

Total connected 

load 

120 Vac, 60 Hz.  

(see table at right for current rating)

Circuit 

requirements

120 Vac, 15 Amp. grounded, dedicated 3-wire 

circuit (hot, neutral, ground)

* At zero inches static pressure

DHW301

DHW361

DHW421

DHW482

Blowers

1

1

1

2

Lights

2 

2

3

4

Filters

1

1

1

2

Maximum 

current draw

3.4 Amp.

3.4 Amp.

3.6 Amp.

6.8 Amp.

IMPORTANT: The minimum installed distance from the hood to the cooking 

surface must be no less than 30 inches. The minimum specified distance 

may be higher for the particular range or cooktop in use. Check the 

manufacturers specifications for the cooktop or range. 

* 18” 1/4 on 48 inch model (DHW482)

All tolerances: ±1/16” (±1.6 mm), -0, unless otherwise stated

•  Observe all governing codes and ordinances during planning 

and installation. Contact your local building department for 

further information.

•  This appliance must be installed in accordance with the 

accompanying installation instructions.

•  DO NOT install an additional in-line or external blower to 

increase the length of the duct run. Even small differences 

between blower air flow rates can greatly reduce the air draw 

of the hood.

Maximum Duct Length
The maximum straight duct length for the hood is 50 feet. To determine the 

actual maximum duct run, subtract the equivalent length of each elbow, 

transition and cap from 50 feet. See the Duct Planning Guide or the 

installation instructions for more details.

 

■

Chimney can accommodate up to 10” round 

duct work

 

■

Unit can be installed to exhaust through the 

ceiling or through the rear wall (see diagram 

below).

(PN AVDH1/AVDH2)
Converts hood to a recirculating 

configuration in instances where 

exhausting the hood outside the 

building is not practical or desired. 

Consists of a top cap and 2 

charcoal filters. When installed, 

the top cap redirects air flow out 

the vents in the sides of the hood 

chimney assembly. The provided 

charcoal filters are installed 

underneath the mesh type filters 

included with the hood. The  

charcoal filters reduce smoke and 

fumes before the hood exhaust 

is vented into the room. Requires 

25 inch long piece of 8 inch round 

duct (not included).

Top cap

8 inch 

duct