Vinotemp VT46TS2ZX Manual Do Proprietário

 

•  Remove all packing material before using your wine cooler.  
•  IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 

24 hours. This will reduce the possibility of a malfunction in the cooling system from handling 
during transportation.   

•  Clean the interior surface with lukewarm water and a soft cloth.  
•  This unit is designed for freestanding and indoor use only. Position the unit in a dry and well-

ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct 
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 
60°F. 

•  For free standing installation, 5 inches (127mm) of space between the back and sides of the unit 

are necessary, which allows the proper air circulation to cool the compressor and condenser for 
energy saving. Even for built-in installation, it is a must to keep ¼” (6.35mm) space on each side 
and at the top. And the air vent at the front of the appliance must never be covered or blocked in 
any way. 

•  Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To 

level the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.  

•  For best performance it is recommended that you install the appliance in a location with an 

ambient temperature between 72°-78°F. If the ambient temperature is above or below 
recommended temperatures, the performance of the unit may be affected.  

•  It is recommended that you do not install the appliance near an oven, radiator or other heating 

source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical 
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best 
performance, do not install the appliance behind a cabinet door or block the base grille. 

•  Avoid locating the unit in moist areas.  
•  Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.  

 c

 F

 

To control this appliance turn on/off. To turn OFF the appliance, touch the    and   marks at the 
same time for 5 seconds.  
 
SET  

 

To set or view the internal temperature setting for each zone.  
 
 

8