Summit RG200W Manual Do Proprietário

Care and cleaning of the range.

Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device is

reengaged properly when the range is replaced. Failure to take this precaution could

result in tipping of the range and cause injury.
To check if the bracket is installed and engaged properly, carefully tip the range forward.

The bracket should stop the range within 4 inches. If it does not, the bracket must be

reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure to verify

the range is properly secured by the anti-tip bracket.
If your range has no anti-tip bracket, call 1.800.932.4267 to receive one at no cost.

WARNING

Lift-Up Cooktop

(on models with standard twin burners)

Clean the area under the cooktop often.

Built-up soil, especially grease, may catch

on fire.
To make cleaning easier, the cooktop may

be lifted up.
NOTE: Do not lift the cooktop on sealed

burner models. Lifting the cooktop can lead

to damage and improper operation of the

range.
To raise the cooktop:
1. Be sure the burners are turned off.
2. Remove the grates.
3. Grasp the two front burner wells and lift

up.

Clean under the cooktop with hot, soapy

water and a clean cloth. If you removed

your surface burners while cleaning, make

sure they are properly seated when

replacing them.
After cleaning, lower the cooktop (be

careful not to pinch your fingers).

Some models have dual support

rods that will hold the cooktop

up while you clean underneath

it.

Your range has two or three professional-

style double grates. These grates are position

specific. For maximum stability, these grates

should only be used in their proper position;

they cannot be interchanged left to right or

front to back. For convenience, the

undersides of the left and right grates are

marked "LEFT FRONT" and "RIGHT FRONT."

Make sure the front portion of both grates is

in front. The middle grate has a bow in front.

Make sure the bowed portion is toward the

front of the range. In addition, the middle

grate is supported by the left and right

grates and must be installed LAST for stability.
Cleaning
Lift out when cool. Grates should be washed

regularly and, of course, after spillovers.

Wash them in hot, soapy water and rinse

with clean water. When replacing the

grates, be sure they are positioned securely

over the burners.

Burner Grates

Replace the grates so that continuous arcs

are formed with the center ribs of all three

grates.
Do not operate a burner for an extended

period of time without cookware on the

grate. The finish on the grate may chip

without cookware to absorb the heat.
To get rid of burned-on food, place the

grates in a covered container. Add 1/4 cup

ammonia and let them soak several hours or

overnight. Wash, rinse well and dry.
Although they are durable, the grates will

gradually lose their shine, regardless of the

best care you can give them. This is due to

their continual exposure to high

temperatures. You will notice this sooner with

lighter color grates.
NOTE: Do not clean the grates in a self-

cleaning oven.