Frigidaire FGGF304DPF Instrução De Instalação

Página de 32
8
30" GAS RANGE INSTALLATION INSTRUCTIONS
Correct burner 
Cap Placement - 
fig. 8
Incorrect burner 
Cap Placement - 
fig. 9
fig. 10
burner Cap
burner 
head
fig. 7
burner Cap Lip
5
 electrical Requirements
120 volt, 60 Hertz, properly grounded dedicated circuit 
protected by a 15 amp circuit breaker or time delay fuse.
Note: Not recommended to be installed with a Ground 
Fault Interrupt (GFI).
do not use an extension cord with this range.
grounding Instructions
IMPORTANT Please read carefully.
for personal safety, this appliance must be 
properly grounded.
The power cord of this appliance is equipped with a 
3-prong (grounding) plug which mates with a standard 
3-prong grounding wall receptacle (see Figure 6) to 
minimize the possibility of electric shock hazard from the 
appliance.
The wall receptacle and circuit should be checked by 
a qualified electrician to make sure the receptacle is 
properly grounded.
6
 Assembly of the burner Caps
Refer to the Use and Care Guide packaged with the 
cooktop for operating instructions and for care and 
cleaning of your cooktop.
 Do not touch the burners. They may 
be hot enough to cause burns.
Install burner Caps
This cooktop is equipped with sealed burners. All pieces 
are at their place. Take note where they are. Remove all 
packaging material. Make sure the burner caps are 
properly aligned and leveled. The burner cap lip (See 
Figure 7) should fit snug into the center of burner head 
and rest level. Refer to Figures 8 & 9 for correct and 
incorrect burner cap placement. Once in place, you may 
check the fit by gently sliding the burner cap from side 
to side (Figure 10) to be sure it is centered and firmly 
seated. When the burner cap lip makes contact inside 
the center of the burner head you will be able to feel 
it. Please note that the burner cap should NOT move 
off the center of the burner head when sliding from 
side to side. NOTE: There are no burner adjustments 
necessary on this cooktop.
Preferred Method
grounding type 
wall receptacle
do not, under any 
circumstances, 
cut, remove, 
or bypass the 
grounding prong.
Power supply 
cord with 3-prong 
grounding plug.
figure 6
Where a standard 2-prong wall receptacle is installed, 
it is the personal responsibility and obligation of the 
consumer to have it replaced by a properly grounded 
3-prong wall receptacle.
do not, under any circumstances, cut or remove 
the third (ground) prong from the power cord.
 Disconnect electrical supply cord from 
wall receptacle before servicing cooktop.